Differences

This shows you the differences between two versions of the page.

--- vertical_bandsaw [2018/11/28 00:51] – sdh7
+++ vertical_bandsaw [2018/11/28 01:20] – sdh7
@@ Line 12: / Line 12: @@
 ^Contact| Sam Harmon|
-Current Status: Needs a ton of work
+Current Status: Needs a lot of work, but does power up
-@@Additional Information@@
+Additional Information
-This was a donation from Akron Makerspace.
+This was a donation from Akron Makerspace. It's a Bett-Marr 14S, vintage 1942-1956 (or maybe later?). Motor is dated 1986.
-  * Needs power cord (12/3, as it's a 16 A motor)
+  * <del>Needs power cord (12/3, as it's a 16 A motor)</del> Fixed, though plug is 15A for now.
-  * Should have a better power switch installed.
+  * Should have a better power switch installed. A nice, emergency-stoppy one.
-  * Probably needs a new belt
+  * Probably needs a new belt - size?
   * There's sort-of a bodged welding job that needs to be ground off, have rust cleaned off and re-welded.
-  * Blade should be replaced (95 1/2" x ?? wide x ?? thick)
+    * This has been worked around for now, but long-term should be fixed better
-  * Remove the light attachment - it's a mess and not helping anything
+  * Blade should be replaced (note inside door says 95 1/2" x 1/2" wide x 0.025" thick)
+  * <del>Remove the light attachment - it's a mess and not helping anything</del>
+  * Add a guard to the belt/chain mechanism
+  * Add a guard to the blade
+  * extend the current guidepost to drop lower?
+  * Table needs refinishing - rather rusty
+  * A nice repainting on the body wouldn't hurt either.
+  * New tires? Probably not a priority right now, but eventually?
 {{tag>[needs_maintenance needs_calibration  needs_major_repair needs_details]}}