vertical_bandsaw
This is an old revision of the document!
Vertical Bandsaw
| Name | Vertical Bandsaw |
|---|---|
| Owner | Makers' Alliance |
| Location | Shop Area |
| Training needed | Yes |
| Hackable | No |
| Model | Bett-Marr 14S |
| Serial | UNKNOWN |
| Arrival Date | 2018 |
| Working | No |
| Contact | Sam Harmon |
Current Status: Needs a ton of work
@@Additional Information@@ This was a donation from Akron Makerspace.
- Needs power cord (12/3, as it's a 16 A motor)
- Should have a better power switch installed.
- Probably needs a new belt
- There's sort-of a bodged welding job that needs to be ground off, have rust cleaned off and re-welded.
- Blade should be replaced (95 1/2“ x ?? wide x ?? thick)
- Remove the light attachment - it's a mess and not helping anything
vertical_bandsaw.1543384294.txt.gz · Last modified: 2018/11/28 05:51 by sdh7