shopsmith_mark_v
This is an old revision of the document!
Shopsmith Mark V
| Name | Shopsmith Mark V |
|---|---|
| Owner | Makers' Alliance |
| Location | Shop Zone |
| Training needed | yes |
| Hackable | no |
| Model | Mark V |
| Serial | UNKNOWN |
| Arrival Date | 2014 |
| Working | yes |
| Contact | Sam Harmon |
Current Status: Reasonably Functional, not all functions tested.
An original Shopsmith Mark V (1955ish Vintage), with Bandsaw and Beltsander, Table saw, Scroll saw, and other tooling.
Current Status: Decently functional, though not all functions have been tested.
Functions tested and working:
- Belt sander
- Bandsaw
Functions of unknown usability:
- Wood Lathe
- Would need a faceplate ($25-35, depending on size) and MT2 tailstock center ($20-40 from shopsmith, or probably less on ebay)
- Table saw
- We have a number of (old, rusty, scary) blades. I have not seen a table saw arbor anywhere in the box of shopsmith accessories we have (a new one will be $31.99)
- Disc Sander
- We do have the sanding disc. untested.
- Drill Press
- We do have the drill chuck & key. untested.
- Scroll saw
- This has leaked an enormous amount of oil. ???
Notes:
- Beltsander belts are 6“x 48” - have a couple from Harbor Freight.
- Bandsaw blades are 72“. We have one spare in the packaging currently.
- Disc sander is 12”
- Belt should be replaced soon ($20 - http://www.shopsmith.com/service/svc_dtl.htm?item=521682&num=113)
shopsmith_mark_v.1486611228.txt.gz · Last modified: 2017/02/08 22:33 by sdh7