This shows you the differences between two versions of the page.
monoprice_maker_ultimate_3d_printer [2019/06/17 11:14] sdh7 Created from the form at tool_submission_form |
monoprice_maker_ultimate_3d_printer [2019/07/19 17:44] (current) sdh7 |
||
---|---|---|---|
Line 16: | Line 16: | ||
Donated in May 2019. | Donated in May 2019. | ||
- | This is Monoprices rebranded Wanhao Duplicator 6. Has the add on sides/top/doors, so ABS printing is a possibility, as well as other "exotic" filaments. | + | This is Monoprices rebranded Wanhao Duplicator 6. Has the add on sides/top/doors, so ABS printing is a possibility(?), as well as other "exotic" filaments. |
- | It was largely functional upon receipt, though it had a filament jam, and, and upon trying to replace the filament again, jammed up again. It needs a hotend replacement (on order). There are also some other minor issues that should be addressed (extruder thermistor cable is maybe loose, and causes interruptions in use?) | + | Upgrades/Modifications since receipt: |
+ | * Replaced hotend/nozzle with a Micro Swiss | ||
+ | * Printed a retaining clip for the extruder | ||
+ | Upgrades/Modifications needed: | ||
+ | * There is some kind of issue with the X/Y axis motion that occasionally screws up really bad (grinding sound, extruder gets way off-course and ruins the print | ||
+ | * Belts? Pulleys? | ||
{{tag>[needs_maintenance needs_calibration needs_minor_repair ]}} | {{tag>[needs_maintenance needs_calibration needs_minor_repair ]}} |