Differences

This shows you the differences between two versions of the page.

--- monoprice_maker_ultimate_3d_printer [2019/06/17 11:14] – Created from the form at tool_submission_form sdh7
+++ monoprice_maker_ultimate_3d_printer [2021/06/11 16:01] (current) – sdh7
@@ Line 12: / Line 12: @@
 ^Contact| Sam Harmon|
-Current Status: Needs repair
+Current Status: Functional
 Donated in May 2019.
-This is Monoprices rebranded Wanhao Duplicator 6. Has the add on sides/top/doors, so ABS printing is a possibility, as well as other "exotic" filaments.
+This is Monoprice's rebranded Wanhao Duplicator 6. Has the add on sides/top/doors, so ABS printing is a possibility, as well as other "exotic" filaments.
-It was largely functional upon receipt, though it had a filament jam, and, and upon trying to replace the filament again, jammed up again. It needs a hotend replacement (on order). There are also some other minor issues that should be addressed (extruder thermistor cable is maybe loose, and causes interruptions in use?)
+Upgrades/Modifications since receipt:
+  * Replaced hotend/nozzle with a Micro Swiss
+  * Printed a retaining clip for the extruder
+  * Replaced X/Y rods that had become bent and were causing problems
+  * Made a silicone hotend sock to prevent inadvertent cool down events that cancel the print in progress.
-{{tag>[needs_maintenance needs_calibration needs_minor_repair  ]}}
+As of June 2021, we are now using this as our dedicated ABS printer, due to its enclosed nature. It is also attached via USB to our Octoprint Server, so GCODE uploading can be done via that.
+Upgrades/Modifications needed:
+  * Buildtak or tape on the build surface might be nice. There's a ground-in Benchy outline on the current Buildtak-like surface (it was like that when we got it!)
+{{tag>[  ]}}