monoprice_maker_ultimate_3d_printer
This is an old revision of the document!
Monoprice Maker Ultimate 3D Printer
| Name | Monoprice Maker Ultimate 3D Printer |
|---|---|
| Owner | Makers' Alliance |
| Location | Digital/Electronics |
| Training needed | No |
| Hackable | Yes |
| Model | Maker Ultimate |
| Serial | UNKNOWN |
| Arrival Date | UNKNOWN |
| Working | No |
| Contact | Sam Harmon |
Current Status: Needs repair
Donated in May 2019.
This is Monoprices rebranded Wanhao Duplicator 6. Has the add on sides/top/doors, so ABS printing is a possibility, as well as other “exotic” filaments.
It was largely functional upon receipt, though it had a filament jam, and, and upon trying to replace the filament again, jammed up again. It needs a hotend replacement (on order). There are also some other minor issues that should be addressed (extruder thermistor cable is maybe loose, and causes interruptions in use?)
monoprice_maker_ultimate_3d_printer.1560784480.txt.gz · Last modified: 2019/06/17 15:14 by sdh7