davinci_xyz_1.0
This is an old revision of the document!
DaVinci XYZ 1.0
| Name | DaVinci XYZ 1.0 |
|---|---|
| Owner | Makers' Alliance |
| Location | 3D printing |
| Training needed | No |
| Hackable | No |
| Model | XYZ 1.0 |
| Serial | - |
| Arrival Date | 6/1/2021 |
| Working | No |
| Contact | Makers' Alliance |
Current Status: Needs Calibration
Updated the stock firmware to Repetier 0.92, so it no longer needs chipped filament. We've tested moving the axes around and heated up the bed/extruder and those seem fine.
Talks to Repetier-Host on my laptop, but not Cura?
Next steps are to manually level the bed, attempt a print, and then hook it into our Octoprint setup.
davinci_xyz_1.0.1644459066.txt.gz · Last modified: 2022/02/10 02:11 by sdh7