Differences

This shows you the differences between two versions of the page.

--- davinci_xyz_1.0 [2022/02/10 02:11] – sdh7
+++ davinci_xyz_1.0 [2022/04/13 03:10] (current) – sdh7
@@ Line 9: / Line 9: @@
 ^Serial| -|
 ^Arrival Date| 6/1/2021|
-^Working| No|
+^Working| Yes|
 ^Contact| Makers' Alliance|
 Current Status: Needs Calibration
-Updated the stock firmware to [[https://github.com/luc-github/Repetier-Firmware-4-Davinci|Repetier 0.92]], so it no longer needs chipped filament. We've tested moving the axes around and heated up the bed/extruder and those seem fine.
+Updated the stock firmware to [[https://github.com/luc-github/Repetier-Firmware-4-Davinci|Repetier 0.92]], so it no longer needs chipped filament (Yay!).
-Talks to Repetier-Host on my laptop, but not Cura?
+Now part of the [[Octoprint]] farm - http://octoprint.local:8084
-Next steps are to manually level the bed, attempt a print, and then hook it into our [[Octoprint]] setup.
+For your Cura Profiles:
+Start Gcode:
+<code>
+G28
+</code>
+End Gcode:
+<code>
+M104 S0
+M140 S0
+G91
+G1 F150
+G1 Z10
+G90
+G28 X0
+G28 Y0
+M8
+</code>
+Build Envelope is 200x200x200. Gcode Flavor is Repetier.
+Also note that the build platform is a little backwards compared to the other printers- the origin is the back left of the print bed, so prints will be "mirrored" relative to where you put them in Cura.
 {{tag>[needs_maintenance needs_calibration   ]}}