User Tools

Site Tools


vidiffektor

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

vidiffektor [2018/08/22 11:23] (current)
sdh7 created
Line 1: Line 1:
  
 +This just covers the basic assembly. If you're putting this in another enclosure, you're on your own...
 +
 +  * Resistors - This kit uses 1% tolerance resistors (blue body, brown tolerance band), and are kind of different than the usual 5% resistors you see
 +    * 470 ohm (yellow-violet black brown brown)
 +    * 2.2 Kohm (red-red- black...)
 +    * 1 k (3) (brown-black black ...)
 +  * Diodes - 1n4001 (black w/silver stripe), and 1N4148 (glass body, w/black stripe)
 +  * IC sockets - one is 16 pin, one is 14 pin. Note the orientation,​ and don't put the 14 pin one in the 16 pin holes...
 +  * LED - flat side on the silkscreen corresponds to the short leg of the LED (or flat side of the LED)
 +  * DC input jack - solder in one pin first and re-align if necessary. Solder in remaining pins
 +  * RCA jacks
 +  * Pots - B0502 (5k x2) B0503 (50K) B0102 (1k x2)
 +  * Standoff "​feet"​
 +  * Insert ICs (LM339 (14 pin), 4040 (16 pin)
 +  * Apply power (6-12V, tip positive) - we tested varying power supplies, and got good performance down to 6V. At 4.5V, some color detail was lost. We didn't attempt to try lower power settings or a "​starve"​ circuit.
 +  * Hook up your input & output and you're done! Have fun vidiffekting!
vidiffektor.txt ยท Last modified: 2018/08/22 11:23 by sdh7