vertical_bandsaw
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
vertical_bandsaw [2018/11/21 01:10] – sdh7 | vertical_bandsaw [2018/11/28 01:20] – sdh7 | ||
---|---|---|---|
Line 6: | Line 6: | ||
^Training needed| Yes| | ^Training needed| Yes| | ||
^Hackable| No| | ^Hackable| No| | ||
- | ^Model| | + | ^Model| |
^Serial| UNKNOWN| | ^Serial| UNKNOWN| | ||
^Arrival Date| 2018| | ^Arrival Date| 2018| | ||
Line 12: | Line 12: | ||
^Contact| Sam Harmon| | ^Contact| Sam Harmon| | ||
- | Current Status: Needs a ton of work | + | Current Status: Needs a lot of work, but does power up |
- | @@Additional Information@@ | + | Additional Information |
- | This was a donation from Akron Makerspace. | + | This was a donation from Akron Makerspace. It's a Bett-Marr 14S, vintage 1942-1956 (or maybe later?). Motor is dated 1986. |
- | * Needs power cord (12/3, as it's a 16 A motor) | + | * <del>Needs power cord (12/3, as it's a 16 A motor)</ |
- | * Should have a better power switch installed. | + | * Should have a better power switch installed. A nice, emergency-stoppy one. |
- | * Probably needs a new belt | + | * Probably needs a new belt - size? |
* There' | * There' | ||
- | | + | * This has been worked around for now, but long-term should be fixed better |
- | * Remove the light attachment - it's a mess and not helping anything | + | |
+ | * <del>Remove the light attachment - it's a mess and not helping anything</ | ||
+ | * Add a guard to the belt/chain mechanism | ||
+ | * Add a guard to the blade | ||
+ | * extend the current guidepost to drop lower? | ||
+ | * Table needs refinishing - rather rusty | ||
+ | * A nice repainting on the body wouldn' | ||
+ | * New tires? Probably not a priority right now, but eventually? | ||
{{tag> | {{tag> |
vertical_bandsaw.txt · Last modified: 2019/01/04 11:59 by sdh7