User Tools

Site Tools


shopsmith_mark_v

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
shopsmith_mark_v [2018/11/21 00:58]
sdh7
shopsmith_mark_v [2018/12/10 16:33]
sdh7
Line 24: Line 24:
   * Wood Lathe   * Wood Lathe
     * Would need a faceplate ($25-35, depending on size) and MT2 tailstock center ($20-40 from shopsmith, or probably less on ebay). Other options would be a chuck or spur center.     * Would need a faceplate ($25-35, depending on size) and MT2 tailstock center ($20-40 from shopsmith, or probably less on ebay). Other options would be a chuck or spur center.
 +    * We have a couple of MT2 live centers for the tailstock.
   * Table saw   * Table saw
     * We have a number of (old, rusty, scary) blades. I have not seen a table saw arbor anywhere in the box of shopsmith accessories we have (a new one will be $31.99)     * We have a number of (old, rusty, scary) blades. I have not seen a table saw arbor anywhere in the box of shopsmith accessories we have (a new one will be $31.99)
-  ​* Drill Press+    * Quite frankly, it's not really worth using the table saw on this- we have two other table saws that are probably better. 
 +  ​* Drill Press/horzintal boring
     * We do have the drill chuck & key. untested.     * We do have the drill chuck & key. untested.
 +    * Using a a drill press is probably a pain compared to using one of the other drill presses at the space due to the setup involved. However, if you need to horizontally bore something big, this may be a good method to do so.
   * Scroll saw   * Scroll saw
     * This has leaked an enormous amount of oil. ???     * This has leaked an enormous amount of oil. ???
 +    * We have another scroll saw.
  
 Notes: Notes:
shopsmith_mark_v.txt · Last modified: 2018/12/10 16:33 by sdh7