User Tools

Site Tools


hot_wire_cutter

This is an old revision of the document!


Hot Wire Cutter

Name Hot Wire Cutter
Owner Steve Gray
Location Shop Zone
Training needed yes
Hackable no
Model N/A
Serial N/A
Arrival Date 2014
Working yes
Contact Steve Gray

Current Status: Original 1-2 A rectifier system replaced with 6A power supply and PWM regulator. Way more power than necessary. Wire gets red hot in a few seconds at 30-50% on the controller.

A DIY'd hot wire cutter on loan from Steve. Uses a Craftsman router table as its table.

The power light is non-functional, so unplug after using.

hot_wire_cutter.1542209311.txt.gz · Last modified: 2018/11/14 10:28 by sdh7

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki