hot_wire_cutter
Hot Wire Cutter
| Name | Hot Wire Cutter |
|---|---|
| Owner | Steve Gray |
| Location | Shop Zone |
| Training needed | yes |
| Hackable | no |
| Model | N/A |
| Serial | N/A |
| Arrival Date | 2014 |
| Working | yes |
| Contact | Steve Gray |
Current Status: Original 1-2 A rectifier system replaced with 6A power supply and PWM regulator. Way more power than necessary. Wire gets red hot in a few seconds at 30-50% on the controller.
A DIY'd hot wire cutter on loan from Steve. Uses a Craftsman router table as its table.
You'll know if it's still on, as it makes quite a hum when it's getting power. Unplug when not in use.
hot_wire_cutter.txt · Last modified: 2018/11/14 15:29 by sdh7