function_generator
Differences
This shows you the differences between two versions of the page.
Last revisionBoth sides next revision | |||
function_generator [2019/04/30 13:03] – created sdh7 | function_generator [2019/04/30 14:21] – sdh7 | ||
---|---|---|---|
Line 21: | Line 21: | ||
No experience needed. | No experience needed. | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | PROCEDURE | ||
+ | Resistors: | ||
+ | * R1 - 1K (brown-black-black-brown-brown) | ||
+ | * R4 - 330 Ohm (orange-orange-black-black-brown) | ||
+ | * R3,R5,R6 - 5.1K (green-brown-black-brown-brown) | ||
+ | IC Socket - Solder one pin first, and make any adjustments if necessary | ||
+ | Ceramic Capacitors: | ||
+ | * C2 - 0.1 uF (104) | ||
+ | * C5 - 1 uF (105) | ||
+ | * C6 - .047 uF (473) | ||
+ | * C7 - .0022 uF (222) | ||
+ | * C8 - .000010 uF (101) | ||
+ | Electrolytic Capacitors (WATCH POLARITY!!!) - Striped location on the silkscreen indicates the negative leg | ||
+ | * C1 - 100 uF | ||
+ | * C3, C4 - 10 uF | ||
+ | Headers - tack and align before soldering all pins! | ||
+ | * J1/J2 - 4 pin | ||
+ | * the big one - 10 pin | ||
+ | Power input - tack & align | ||
+ | Screw Terminal - P1 - tack and align - make sure metal part is facing out! | ||
+ | Pots - resistance labeled on the underside - they' | ||
+ | R2, R7 - 50K (B503) | ||
+ | R8 - 100K (B104) | ||
+ | |||
+ | insert XR2206 IC | ||
+ | test! | ||
+ | build the enclosure |
function_generator.txt · Last modified: 2019/04/30 22:05 by sdh7