User Tools

Site Tools


enco_drill_press

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
enco_drill_press [2018/01/14 22:17]
sdh7
enco_drill_press [2018/01/14 22:18] (current)
sdh7
Line 35: Line 35:
     * Start with a wooden "proof of concept before making it in aluminum?     * Start with a wooden "proof of concept before making it in aluminum?
     * Cut out hole with hole saw/​CNC/​whatever     * Cut out hole with hole saw/​CNC/​whatever
-    * drill holes to 1/4-20 tap diameter (#7, IIRC), cut in half, tap one half and bore the other?+    * drill holes to 1/4-20 tap diameter (#7, IIRC) or smaller if necessary, cut in half, tap one half and bore the other?
     * use transfer punch to mark where to drill for threaded rod     * use transfer punch to mark where to drill for threaded rod
     * Grizzly sell a variety of threaded "stop collars"​ that would be a massive improvement over nuts on threaded rod, but only available in a handful of sizes (one kind in 3/8" (called a Quill Stop), and the other in 3/8", 1/2", 8mm, and 10mm (Threaded Stop Collars))     * Grizzly sell a variety of threaded "stop collars"​ that would be a massive improvement over nuts on threaded rod, but only available in a handful of sizes (one kind in 3/8" (called a Quill Stop), and the other in 3/8", 1/2", 8mm, and 10mm (Threaded Stop Collars))
  
 {{tag>​[needs_minor_repair needs_details]}} {{tag>​[needs_minor_repair needs_details]}}
enco_drill_press.txt ยท Last modified: 2018/01/14 22:18 by sdh7