enco_drill_press
This is an old revision of the document!
Enco Drill Press
| Name | Enco Drill Press |
|---|---|
| Owner | Makers' Alliance |
| Location | Shop Area |
| Training needed | yes |
| Hackable | no |
| Model | Model Number |
| Serial | Serial Number |
| Arrival Date | December 2015 |
| Working | yes |
| Contact | Sam Harmon |
In December 2015, we acquired an Enco Drill Press from HGR.
Current Status: Functional, but see below
Specifications:
- Chuck - 5/8“ JT3
- Quill feed: 5”?
- Belt - 13mm x 1132mm seems to be the closest measurement (SPA1132)
Work Needed:
- Needs additional feed lever arms (has one, currently)
- These are curious. The existing one is something ever so slightly smaller than 1/2“ (12mm?), but testing a 1/2” bolt in some of the holes seemed to be a good fit, so we should be able to fabricate or find acceptable replacements.
- Suggestion: get a few feet of 1/2“ steel rod and thread one end for 1/2”, and figure out something for the knobs.
- simpler solution - get a few feet of 1/2“ threaded rod and get 1/2” threaded knobs ($3 each from McMaster or Grainger)
Place & bolt back onto standDONE! one bolt seems a bit crooked. Should fix sometime.
Future work that could be done:
- Set up depth stop/gauge mechanism?
enco_drill_press.1484020901.txt.gz · Last modified: 2017/01/10 04:01 by sdh7