Differences

This shows you the differences between two versions of the page.

--- enco_drill_press [2017/01/09 22:13] – sdh7
+++ enco_drill_press [2017/01/09 23:01] – sdh7
@@ Line 23: / Line 23: @@
 Work Needed:
-  *<del>Replace Belt </del> DONE!
-  *<del>Replace light bulb (w/LED)</del> DONE!
-  *<del>Adjust or replace coil spring (quill return seems a bit loose)</del> DONE! (tightened)
   *Needs additional feed lever arms (has one, currently)
     *These are curious. The existing one is something ever so slightly smaller than 1/2" (12mm?), but testing a 1/2" bolt in some of the holes seemed to be a good fit, so we should be able to fabricate or find acceptable replacements.
     *Suggestion: get a few feet of 1/2" steel rod and thread one end for 1/2", and figure out something for the knobs.
     *simpler solution - get a few feet of 1/2" threaded rod and get 1/2" threaded knobs ($3 each from McMaster or Grainger)
-    *<del>Table is loose on the clamp- may just need adjusted?</del> Worked Around!
-    *Table connector diameter - 1.850", clamp diameter - 1.875"
-    *Somehow epoxy .010" shim stock onto the table connector?
-    *Thicken material by welding?
-    *Solution currently in place- a cut up soda can was a thick enough shim to tighten down fully.
   *<del>Place & bolt back onto stand</del> DONE! one bolt seems a bit crooked. Should fix sometime.
@@ Line 40: / Line 32: @@
   *Set up depth stop/gauge mechanism?
-{{tag>[needs_minor_repair]}}
+{{tag>[needs_minor_repair needs_details]}}