davinci_xyz_1.0
Differences
This shows you the differences between two versions of the page.
Last revisionBoth sides next revision | |||
davinci_xyz_1.0 [2022/02/09 20:59] – Created from the form at tool_submission_form sdh7 | davinci_xyz_1.0 [2022/02/09 21:11] – sdh7 | ||
---|---|---|---|
Line 12: | Line 12: | ||
^Contact| Makers' | ^Contact| Makers' | ||
- | Current Status: | + | Current Status: |
- | Updated the stock firmware to Repetier 0.92, so it no longer needs chipped filament. | + | Updated the stock firmware to [[https:// |
+ | |||
+ | Talks to Repetier-Host on my laptop, but not Cura? | ||
+ | |||
+ | Next steps are to manually level the bed, attempt a print, and then hook it into our [[Octoprint]] setup. | ||
{{tag> | {{tag> |
davinci_xyz_1.0.txt · Last modified: 2022/04/12 23:10 by sdh7