Current Status: Needs Calibration

Updated the stock firmware to Repetier 0.92, so it no longer needs chipped filament (Yay!).

Now part of the Octoprint farm - http://octoprint.local:8084

For your Cura Profiles: Start Gcode:

G28

End Gcode:

M104 S0
M140 S0
G91
G1 F150
G1 Z10
G90
G28 X0
G28 Y0
M8

Build Envelope is 200x200x200. Gcode Flavor is Repetier.

Also note that the build platform is a little backwards compared to the other printers- the origin is the back left of the print bed, so prints will be “mirrored” relative to where you put them in Cura.