shopsmith_mark_v
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| shopsmith_mark_v [2018/11/21 05:58] – sdh7 | shopsmith_mark_v [2018/12/10 21:33] (current) – sdh7 | ||
|---|---|---|---|
| Line 24: | Line 24: | ||
| * Wood Lathe | * Wood Lathe | ||
| * Would need a faceplate ($25-35, depending on size) and MT2 tailstock center ($20-40 from shopsmith, or probably less on ebay). Other options would be a chuck or spur center. | * Would need a faceplate ($25-35, depending on size) and MT2 tailstock center ($20-40 from shopsmith, or probably less on ebay). Other options would be a chuck or spur center. | ||
| + | * We have a couple of MT2 live centers for the tailstock. | ||
| * Table saw | * Table saw | ||
| * We have a number of (old, rusty, scary) blades. I have not seen a table saw arbor anywhere in the box of shopsmith accessories we have (a new one will be $31.99) | * We have a number of (old, rusty, scary) blades. I have not seen a table saw arbor anywhere in the box of shopsmith accessories we have (a new one will be $31.99) | ||
| - | | + | * Quite frankly, it's not really worth using the table saw on this- we have two other table saws that are probably better. |
| + | | ||
| * We do have the drill chuck & key. untested. | * We do have the drill chuck & key. untested. | ||
| + | * Using a a drill press is probably a pain compared to using one of the other drill presses at the space due to the setup involved. However, if you need to horizontally bore something big, this may be a good method to do so. | ||
| * Scroll saw | * Scroll saw | ||
| * This has leaked an enormous amount of oil. ??? | * This has leaked an enormous amount of oil. ??? | ||
| + | * We have another scroll saw. | ||
| Notes: | Notes: | ||
shopsmith_mark_v.1542779911.txt.gz · Last modified: 2018/11/21 05:58 by sdh7