Differences

This shows you the differences between two versions of the page.

--- hp_1660cs_logic_analyzer_and_oscilloscope [2019/03/27 01:20] – faehnrich
+++ hp_1660cs_logic_analyzer_and_oscilloscope [2023/10/11 02:05] (current) – davidk
@@ Line 7: / Line 7: @@
 There are PS2 keyboard and mouse ports on the back, but can also be controlled with the buttons on the front.
-To power on, verify it has a power cord plugged in and any power strip that's plugged into is turned on.  The push the button "Line" that's near the bottom of the front panel.
+To power on, verify it has a power cord plugged in and any power strip that's plugged into is turned on.  Then push the button "Line" that's near the bottom of the front panel.
 When powered on, the main functions can be selected with the on-screen button in the upper left.  All on-screen buttons can be selected with the mouse cursor or keyboard and Enter key, but also the front panel arrow and Select buttons.
@@ Line 18: / Line 18: @@
 ==== Oscilloscope ====
+Select the Scope main function.
 TBD
-When Scope mode is selected
+Scope Evaluation With Function Generator
+{{ :hp1660scope.jpg |}}
+^ Date        ^ 1 MHz ^ 100 KHz ^ 10 KHz ^ 1 KHz ^ 100 Hz ^ 10 Hz ^ Comments ^
+| 2023-10-10  | OK  | OK | OK | OK | OK | OK | Evaluated by davidk. Tested Channels C1 and C2 with a sine wave from the Wavetek signal generator. Both Channels performed within expectations with approximately .5% or less deviation. Channels were configured for 50Ω, DC coupling. 100 mV/div |
 ==== Logic Analyzer ====