Differences

This shows you the differences between two versions of the page.

--- hot_wire_cutter [2016/10/30 17:11] – external edit 127.0.0.1
+++ hot_wire_cutter [2018/11/14 15:29] (current) – sdh7
@@ Line 1: / Line 1: @@
+=====Hot Wire Cutter=====
+^Name| Hot Wire Cutter|
+^Owner | Steve Gray |
+^Location | Shop Zone |
+^Training needed| yes|
+^Hackable| no|
+^Model| N/A|
+^Serial| N/A|
+^Arrival Date| 2014|
+^Working| yes |
+^Contact| Steve Gray|
+Current Status: Original 1-2 A rectifier system replaced with 6A power supply and PWM regulator. Way more power than necessary. Wire gets red hot in a few seconds at 30-50% on the controller.
 A DIY'd hot wire cutter on loan from Steve. Uses a Craftsman router table as its table.
+You'll know if it's still on, as it makes quite a hum when it's getting power. Unplug when not in use.
+{{tag>[]}}