bigcnc
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| bigcnc [2019/01/17 17:21] – sdh7 | bigcnc [2019/01/17 17:26] (current) – sdh7 | ||
|---|---|---|---|
| Line 29: | Line 29: | ||
| * Turn down end of leadscrew | * Turn down end of leadscrew | ||
| * Y axis | * Y axis | ||
| + | * Cut down rails to length if necessary? | ||
| * attach rails to base | * attach rails to base | ||
| * tap delrin nuts | * tap delrin nuts | ||
| - | * cut leadscrews | + | * cut leadscrews |
| * turn down leadscrews | * turn down leadscrews | ||
| * Z axis | * Z axis | ||
| - | * < | + | * < |
| * attach to X axis | * attach to X axis | ||
| * Table | * Table | ||
bigcnc.1547745703.txt.gz · Last modified: 2019/01/17 17:21 by sdh7