bigcnc
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| bigcnc [2019/01/15 17:25] – sdh7 | bigcnc [2019/01/17 17:26] (current) – sdh7 | ||
|---|---|---|---|
| Line 29: | Line 29: | ||
| * Turn down end of leadscrew | * Turn down end of leadscrew | ||
| * Y axis | * Y axis | ||
| + | * Cut down rails to length if necessary? | ||
| * attach rails to base | * attach rails to base | ||
| * tap delrin nuts | * tap delrin nuts | ||
| - | * cut leadscrews | + | * cut leadscrews |
| * turn down leadscrews | * turn down leadscrews | ||
| * Z axis | * Z axis | ||
| - | * attach spindle mounts | + | * <del>attach spindle mounts</ |
| * attach to X axis | * attach to X axis | ||
| * Table | * Table | ||
| Line 44: | Line 45: | ||
| * Wire up everything | * Wire up everything | ||
| * Procure motors if needed? | * Procure motors if needed? | ||
| + | * Misc | ||
| + | * Dust collection setup? | ||
| + | * Vacuum hold-downs? (optional) | ||
| + | * < | ||
bigcnc.1547573123.txt.gz · Last modified: 2019/01/15 17:25 by sdh7