User Tools

Site Tools


k40_laser_engraver

This is an old revision of the document!


K40 Laser Engraver

Name K40 Laser Engraver
Owner Sam Harmon
Location Electronics
Training needed Yes
Hackable No
Model K40
Serial NA
Arrival Date 3/17/2018
Working No
Contact Sam Harmon

Current Status: Still under construction (It's a K40…)

Fixes implemented:

  • Bad connection on the power inlet between the hot and fuse. Re-soldered.

Laser does work, though not yet from triggering on the front panel (or via Gcode)

Software: I suggest K40 Whisperer, as the LaserDRW thing it came with is not so hot.

Usage: It's not ready yet, so DON'T USE IT. That said, turn on the outside exhaust fan if you do eventually use it.

Safety considerations: https://techbravo.net/hosting/knowledgebase/4191/CO2-Laser-Engraver-Safety.html

Upgrades to consider in the near term:

Upgrades to consider eventually?:

  • improved controller board (Smoothie? DSP?)

Documentation dump:

k40_laser_engraver.1521727555.txt.gz · Last modified: 2018/03/22 10:05 by sdh7