uv_curing_lamp
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
— | uv_curing_lamp [2019/07/10 11:22] (current) – Created from the form at tool_submission_form sdh7 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | =====UV Curing Lamp===== | ||
+ | ^Name| UV Curing Lamp| | ||
+ | ^Owner | Makers' | ||
+ | ^Location | 3D Printing | | ||
+ | ^Training needed| No| | ||
+ | ^Hackable| No| | ||
+ | ^Model| MelodySusie| | ||
+ | ^Serial| UNKNOWN| | ||
+ | ^Arrival Date| UNKNOWN| | ||
+ | ^Working| Yes| | ||
+ | ^Contact| Sam Harmon| | ||
+ | |||
+ | Current Status: Fully Functional | ||
+ | |||
+ | A UV lamp normally intended for gel nail polish, this device works pretty well for curing SLA 3D prints. It has a couple of timed modes - one is two minutes, the other 30 minutes. The 30 minute setting run a couple of times should be sufficient for curing most SLA prints. | ||
+ | |||
+ | May also be useful for UV glues and/or PCB exposure, but untested for these uses. | ||
+ | |||
+ | There is a spare UV bulb in with the SLA Printing Supplies. | ||
+ | |||
+ | {{tag> |
uv_curing_lamp.txt · Last modified: 2019/07/10 11:22 by sdh7