todo
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
todo [2018/10/05 13:36] – sdh7 | todo [2018/10/05 17:42] – sdh7 | ||
---|---|---|---|
Line 18: | Line 18: | ||
====Shop Zone==== | ====Shop Zone==== | ||
* Continue repairs on the [[Shopsmith Mark V]]- parts are in, what are you waiting for? | * Continue repairs on the [[Shopsmith Mark V]]- parts are in, what are you waiting for? | ||
- | * Move [[Press]] back into the workshop area if it's not already | + | * <del>Move [[Press]] back into the workshop area if it's not already</ |
* Start working on the new-to-us band saw from Akron Makerspace | * Start working on the new-to-us band saw from Akron Makerspace | ||
* Figure out all the stuff it needs done to make it a viable tool | * Figure out all the stuff it needs done to make it a viable tool | ||
Line 27: | Line 27: | ||
* Priority: really low, unless it's driving you crazier than me. | * Priority: really low, unless it's driving you crazier than me. | ||
* Tool organization - any improvements are welcome! | * Tool organization - any improvements are welcome! | ||
- | * Rolling carts/ | + | * <del>Rolling carts/ |
- | * Better stand/mount for the [[Disc Sander]]? | + | * Better stand/mount for the [[Disc Sander]]? |
* Better organization inside the gray bench cabinets in general | * Better organization inside the gray bench cabinets in general | ||
* Electrical wiring for the " | * Electrical wiring for the " | ||
Line 34: | Line 34: | ||
* Build a nice fence for the [[Enco Drill Press]]? | * Build a nice fence for the [[Enco Drill Press]]? | ||
* Measure T-slot nuts for the [[Enco Drill Press]]. See of additional ones are available, or maybe make some. | * Measure T-slot nuts for the [[Enco Drill Press]]. See of additional ones are available, or maybe make some. | ||
- | * Implement Dust Collection Station? | + | * Implement Dust Collection Station? See what repairs the Delta Dust Collector needs? |
- | ====Electronics/ | + | ====" |
* Fastener Organization & labeling | * Fastener Organization & labeling | ||
+ | |||
+ | ====Electronics/ | ||
* Install a set of standardized tools onto laptops | * Install a set of standardized tools onto laptops | ||
* Arduino IDE | * Arduino IDE | ||
Line 62: | Line 64: | ||
* Figure out steps needed to make the [[K40 Laser Engraver]] chooch safely & reasonably | * Figure out steps needed to make the [[K40 Laser Engraver]] chooch safely & reasonably | ||
* Add an Emergency stop? | * Add an Emergency stop? | ||
- | * < | + | * < |
* Figure out water pump/alarm stuff (short version: water pump is running, but flow alarm is triggering? need better pump? replace alarm? right now alarm is shorted out in order to test functionality...) | * Figure out water pump/alarm stuff (short version: water pump is running, but flow alarm is triggering? need better pump? replace alarm? right now alarm is shorted out in order to test functionality...) | ||
* Add air assist | * Add air assist |
todo.txt · Last modified: 2019/10/22 19:09 by sdh7