todo
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
todo [2018/08/07 14:37] – sdh7 | todo [2018/08/07 14:39] – sdh7 | ||
---|---|---|---|
Line 18: | Line 18: | ||
* < | * < | ||
* Continue repairs on the [[Shopsmith Mark V]]- parts are in, what are you waiting for? | * Continue repairs on the [[Shopsmith Mark V]]- parts are in, what are you waiting for? | ||
- | * Move [[Shop Press]] back into the workshop area if it's not already | + | * Move [[Press]] back into the workshop area if it's not already |
* Start working on the new-to-us band saw from Akron Makerspace | * Start working on the new-to-us band saw from Akron Makerspace | ||
* Figure out all the stuff it needs done to make it a viable tool | * Figure out all the stuff it needs done to make it a viable tool | ||
Line 45: | Line 45: | ||
* Inkscape (useful for designing stuff for the vinyl cutter) | * Inkscape (useful for designing stuff for the vinyl cutter) | ||
* Salae Logic | * Salae Logic | ||
+ | * K40 Whisperer | ||
* Other software? | * Other software? | ||
* Maybe first get all of these installers onto a USB stick, so they can be done all at once. | * Maybe first get all of these installers onto a USB stick, so they can be done all at once. | ||
Line 55: | Line 56: | ||
* Optional: Upgrade electronics to something 4-axis ready. | * Optional: Upgrade electronics to something 4-axis ready. | ||
* Get the [[RepRap]]s running again, or for the first time? | * Get the [[RepRap]]s running again, or for the first time? | ||
- | * Figure out steps needed to make the [[Laser Engraver]] chooch safely & reasonably | + | * Figure out steps needed to make the [[K40 Laser Engraver]] chooch safely & reasonably |
* Add an Emergency stop? | * Add an Emergency stop? | ||
* Figure out ventilation - filtration system? | * Figure out ventilation - filtration system? |
todo.txt · Last modified: 2019/10/22 19:09 by sdh7