todo
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
todo [2018/03/09 12:29] – sdh7 | todo [2018/03/10 23:14] – sdh7 | ||
---|---|---|---|
Line 18: | Line 18: | ||
====Shop Zone==== | ====Shop Zone==== | ||
* Continue repairs on the [[Shopsmith Mark V]]. | * Continue repairs on the [[Shopsmith Mark V]]. | ||
- | * Solve Leak in the [[Sand Blaster]] or get a new one. | + | * <del>Solve Leak in the [[Sand Blaster]]</ |
* Drill bit sorting(ok, probably not, but it does drive me crazy) | * Drill bit sorting(ok, probably not, but it does drive me crazy) | ||
* Priority: really low, unless it's driving you crazier than me. | * Priority: really low, unless it's driving you crazier than me. | ||
Line 48: | Line 48: | ||
* DesignJet printer really needs a dust cover, since it gets completely clogged up with dust and debris when not in use. | * DesignJet printer really needs a dust cover, since it gets completely clogged up with dust and debris when not in use. | ||
* Figure out issue with Shapeoko spindle enable - Problem with the Arduino? Wiring? Relay Box? | * Figure out issue with Shapeoko spindle enable - Problem with the Arduino? Wiring? Relay Box? | ||
+ | * Complete [[RepRap Snappy]] | ||
====Electronics==== | ====Electronics==== |
todo.txt · Last modified: 2019/10/22 19:09 by sdh7