shopsmith_mark_v
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| shopsmith_mark_v [2018/07/27 11:55] – sdh7 | shopsmith_mark_v [2018/12/10 16:33] (current) – sdh7 | ||
|---|---|---|---|
| Line 9: | Line 9: | ||
| ^Serial| UNKNOWN| | ^Serial| UNKNOWN| | ||
| ^Arrival Date| 2014| | ^Arrival Date| 2014| | ||
| - | ^Working| | + | ^Working| |
| ^Contact| Sam Harmon| | ^Contact| Sam Harmon| | ||
| - | Current Status: | + | Current Status: |
| An original Shopsmith Mark V (1955-1962? Vintage), with Bandsaw and Beltsander, Table saw, Scroll saw, and other tooling. | An original Shopsmith Mark V (1955-1962? Vintage), with Bandsaw and Beltsander, Table saw, Scroll saw, and other tooling. | ||
| - | |||
| - | Current Status: Decently functional, though not all functions have been tested. | ||
| Functions tested and working: | Functions tested and working: | ||
| Line 26: | Line 24: | ||
| * Wood Lathe | * Wood Lathe | ||
| * Would need a faceplate ($25-35, depending on size) and MT2 tailstock center ($20-40 from shopsmith, or probably less on ebay). Other options would be a chuck or spur center. | * Would need a faceplate ($25-35, depending on size) and MT2 tailstock center ($20-40 from shopsmith, or probably less on ebay). Other options would be a chuck or spur center. | ||
| + | * We have a couple of MT2 live centers for the tailstock. | ||
| * Table saw | * Table saw | ||
| * We have a number of (old, rusty, scary) blades. I have not seen a table saw arbor anywhere in the box of shopsmith accessories we have (a new one will be $31.99) | * We have a number of (old, rusty, scary) blades. I have not seen a table saw arbor anywhere in the box of shopsmith accessories we have (a new one will be $31.99) | ||
| - | | + | * Quite frankly, it's not really worth using the table saw on this- we have two other table saws that are probably better. |
| + | | ||
| * We do have the drill chuck & key. untested. | * We do have the drill chuck & key. untested. | ||
| + | * Using a a drill press is probably a pain compared to using one of the other drill presses at the space due to the setup involved. However, if you need to horizontally bore something big, this may be a good method to do so. | ||
| * Scroll saw | * Scroll saw | ||
| * This has leaked an enormous amount of oil. ??? | * This has leaked an enormous amount of oil. ??? | ||
| + | * We have another scroll saw. | ||
| Notes: | Notes: | ||
shopsmith_mark_v.txt · Last modified: 2018/12/10 16:33 by sdh7