This is an old revision of the document!
In 2013, Sam purchased a Shapeoko kit. Made good progress at first, and then it languished in his garage for a few years.
In December 2015, he took it to the space in hopes it would get finished there. It's making progress already 
Electronics: Arduino Uno with gShield. Computer is a BeagleBone Black.
Current status: Starting to function. Needs more calibration, and limit switches, spindle control, etc.
To-Do List
Calibration: seems ok at the moment. Maybe double check with a dial indicator?
Limit Switches: Use mechanical switches for X-/X+/Y-/Y+/Z+. Maybe build/buy a touch plate setup for Z-?
Spindle control: Set it up like the MaxNC, with gshield driving a transistor, that in turn drives a relay that powers the spindle.
Software: Install ChiliPeppr and necessary add-ons to make it usable. , possibly running Chilipeppr eventually?