move_punchlist
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| move_punchlist [2017/02/28 18:14] – sdh7 | move_punchlist [2018/05/11 15:04] – sdh7 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | In February 2017, we're moving to another location within | + | April 2018 - We have moved from The Dealership |
| - | IMPORTANT: | + | Things to do at Hamilton: |
| - | * If you have big, unwieldy stuff that we don't have room for- MAKE IT GO AWAY. | + | * 120V 20A run - get 50' of 12/3, use L5-20 connector from John K. and set up a 4-outlet box by benches |
| + | * Replace fluorescent light with LED (budget: $40/each for 3200 Lumen units) | ||
| + | * Plan B- replace fluorescent tubes w/LED Drop-in replacements($7-10 each) | ||
| + | * Plan C- Bob is getting some 8' | ||
| + | * Run ethernet cable to Soulcraft/ | ||
| + | * A stepstool to reach shelf tops? We' | ||
| + | * Organize things where they should go - re-label shelves to indicate contents | ||
| + | * Figure out what we're doing with the radio shack cabinets? | ||
| + | * Set up audio system | ||
| - | Tasks remaining to be done: | ||
| - | * Figure out which panel/ | ||
| - | * Add one additional outlet, possibly additional boxes/ | ||
| - | * for the one spot where a box could be easily added, a 4-outlet box would be nice. | ||
| - | *< | ||
| - | * Figure out what to do with the casting furnace | ||
| - | * I would like to build a much smaller one using the refractory on hand. | ||
| - | * < | ||
| - | * TVH have a source that can get replacement bulbs fairly cheap | ||
| - | |||
| - | Everything is moved. Some things still need to be installed/ | ||
| - | |||
| - | Things that would be useful to have: | ||
| - | * 19" rackmount shelves (a couple) | ||
| - | * more caster-equipped benches for tools (miter saw, etc.) | ||