monoprice_mp_select_mini
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
monoprice_mp_select_mini [2016/11/22 04:40] – sdh7 | monoprice_mp_select_mini [2017/01/10 19:59] – sdh7 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | =====Monoprice MP Select Mini 3D Printer===== | ||
+ | |||
+ | ^Name| MP Select Mini| | ||
+ | ^Owner | Sam Harmon | | ||
+ | ^Location | Electronics | | ||
+ | ^Training needed| yes| | ||
+ | ^Hackable| no| | ||
+ | ^Model| Model Number| | ||
+ | ^Serial| Serial Number| | ||
+ | ^Arrival Date| October 2016| | ||
+ | ^Working| yes| | ||
+ | ^Contact| Sam Harmon| | ||
+ | |||
+ | Current Status: Fully Functional | ||
+ | |||
NOTE: This 3D printer is Sam's personal property, **not** the space' | NOTE: This 3D printer is Sam's personal property, **not** the space' | ||
Line 10: | Line 25: | ||
*Extuder (hot end) upgrade: an E3D V6 clone hotend has been procured. A mount for it will need to be printed in ABS (or stronger). Need to print the mount soon (as a just-in-case measure), but no need to perform the replacement until necessary. | *Extuder (hot end) upgrade: an E3D V6 clone hotend has been procured. A mount for it will need to be printed in ABS (or stronger). Need to print the mount soon (as a just-in-case measure), but no need to perform the replacement until necessary. | ||
*Other modifications: | *Other modifications: | ||
+ | |||
+ | {{tag> | ||
+ | |||
+ |
monoprice_mp_select_mini.txt · Last modified: 2022/10/26 14:54 by sdh7