monoprice_maker_ultimate_3d_printer
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
Next revision | |||
— | monoprice_maker_ultimate_3d_printer [2019/06/17 11:14] – Created from the form at tool_submission_form sdh7 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | =====Monoprice Maker Ultimate 3D Printer===== | ||
+ | ^Name| Monoprice Maker Ultimate 3D Printer| | ||
+ | ^Owner | Makers' | ||
+ | ^Location | Digital/ | ||
+ | ^Training needed| No| | ||
+ | ^Hackable| Yes| | ||
+ | ^Model| Maker Ultimate| | ||
+ | ^Serial| UNKNOWN| | ||
+ | ^Arrival Date| UNKNOWN| | ||
+ | ^Working| No| | ||
+ | ^Contact| Sam Harmon| | ||
+ | |||
+ | Current Status: Needs repair | ||
+ | |||
+ | Donated in May 2019. | ||
+ | |||
+ | This is Monoprices rebranded Wanhao Duplicator 6. Has the add on sides/ | ||
+ | |||
+ | It was largely functional upon receipt, though it had a filament jam, and, and upon trying to replace the filament again, jammed up again. It needs a hotend replacement (on order). There are also some other minor issues that should be addressed (extruder thermistor cable is maybe loose, and causes interruptions in use?) | ||
+ | |||
+ | {{tag> |
monoprice_maker_ultimate_3d_printer.txt · Last modified: 2021/06/11 16:01 by sdh7