make_your_own_arduino
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
make_your_own_arduino [2018/12/01 14:11] – sdh7 | make_your_own_arduino [2018/12/01 14:49] – sdh7 | ||
---|---|---|---|
Line 37: | Line 37: | ||
* Programming header | * Programming header | ||
* tack in pin and adjust if necessary | * tack in pin and adjust if necessary | ||
- | * Microcontroller | ||
- | * ORIENTATION CRITICAL | ||
* Jumpers (somewhat optional, and notice that they are zero-ohm resistors!) | * Jumpers (somewhat optional, and notice that they are zero-ohm resistors!) | ||
* NOTE: The Diavolino does not have any protection from multiple voltage sources. You *must* be a little careful when powering it. If using USB power, TURN THE BATTERY PACK OFF! | * NOTE: The Diavolino does not have any protection from multiple voltage sources. You *must* be a little careful when powering it. If using USB power, TURN THE BATTERY PACK OFF! | ||
* USBV Jumper - if you don't want to use the battery pack, or want it to be powerable via USB, install this jumper. | * USBV Jumper - if you don't want to use the battery pack, or want it to be powerable via USB, install this jumper. | ||
* Regulator jumper- if you want to use a 5V wall power supply, you can install this jumper. If you want to use a 9V (or greater) power supply, DO NOT INSTALL THIS JUMPER. | * Regulator jumper- if you want to use a 5V wall power supply, you can install this jumper. If you want to use a 9V (or greater) power supply, DO NOT INSTALL THIS JUMPER. | ||
- | * Battery Pack (optional) | ||
- | * Use the holes near the solder points for strain relief on the cables | ||
- | * Pack can be foam-taped to the underside of the board, if you want | ||
* Headers | * Headers | ||
* Solder these carefully- proper alignment is important! | * Solder these carefully- proper alignment is important! | ||
* Tack one pin of each on, then adjust as necessary | * Tack one pin of each on, then adjust as necessary | ||
+ | * Microcontroller | ||
+ | * ORIENTATION CRITICAL | ||
+ | * Battery Pack (optional) | ||
+ | * Use the holes near the solder points for strain relief on the cables | ||
+ | * Pack can be foam-taped to the underside of the board, if you want | ||
* Power on test | * Power on test | ||
* Apply power (via batteries or USB) | * Apply power (via batteries or USB) |
make_your_own_arduino.txt · Last modified: 2019/07/25 17:02 by sdh7