User Tools

Site Tools


k40_laser_engraver

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
k40_laser_engraver [2018/11/20 14:35]
sdh7
k40_laser_engraver [2019/02/14 17:32] (current)
sdh7
Line 48: Line 48:
   * Wood (engraving) - 8% does a fine job on the random wood pieces we've tested with.   * Wood (engraving) - 8% does a fine job on the random wood pieces we've tested with.
   * wood (cutting) - 11% was sufficient to cut 3mm baltic birch plywood?   * wood (cutting) - 11% was sufficient to cut 3mm baltic birch plywood?
-  * Acrylic - 25% was great for engraving, but slightly insufficient for cutting (the cut edges did snap off easily, though)+  * Acrylic - 25% was great for engraving, but slightly insufficient for cutting (the cut edges did snap off easily, though). 33-35% should be good for cutting at 10mm/s.
  
  
Line 55: Line 55:
   * <​del>​Fire Extinguisher</​del>​ done   * <​del>​Fire Extinguisher</​del>​ done
   * Air assist (pump acquired, need to get tubing/​fittings/​etc.)   * Air assist (pump acquired, need to get tubing/​fittings/​etc.)
-  * honeycomb base (http://​www.scorchworks.com/​Blog/​spring-loaded-k40-laser-platform/​ for a good way to do it)+  ​<del>* honeycomb base (http://​www.scorchworks.com/​Blog/​spring-loaded-k40-laser-platform/​ for a good way to do it)</​del>​ done
   * <​del>​Thermometer & flow meter for cooling pump (i.e. https://​www.amazon.com/​Thermometer-Cooling-Liquid-Cooler-System/​dp/​B074SDFW51/​ref=sr_1_3?​s=electronics&​ie=UTF8&​qid=1521656040&​sr=8-3&​keywords=LED+Thermometer+3+Way+Flow+Meter+FlowMeter+For+Water+Cooling+Liquid+Cooler+System)</​del>​ ordered   * <​del>​Thermometer & flow meter for cooling pump (i.e. https://​www.amazon.com/​Thermometer-Cooling-Liquid-Cooler-System/​dp/​B074SDFW51/​ref=sr_1_3?​s=electronics&​ie=UTF8&​qid=1521656040&​sr=8-3&​keywords=LED+Thermometer+3+Way+Flow+Meter+FlowMeter+For+Water+Cooling+Liquid+Cooler+System)</​del>​ ordered
   *<​del>​ improved chiller pump</​del>​ done   *<​del>​ improved chiller pump</​del>​ done
k40_laser_engraver.1542742505.txt.gz ยท Last modified: 2018/11/20 14:35 by sdh7