User Tools

Site Tools


k40_laser_engraver

This is an old revision of the document!


K40 Laser Engraver

Name K40 Laser Engraver
Owner Sam Harmon
Location Electronics
Training needed Yes
Hackable No
Model K40
Serial NA
Arrival Date 3/17/2018
Working No
Contact Sam Harmon

Current Status: Still under construction (It's a K40…)

Fixes implemented:

  • Bad connection on the power inlet between the hot and fuse. Re-soldered.
  • Jumpered water break detection since detector is NFG.
    • Test again with new coolant pump to make sure it wasn't just low flow?

Fix needed:

  • need to replace K+/K- cable. We should have a pile of the correct kind in the through-hole connector bin (hooked up to thermistors, but one can be sacrificed for this)
  • Figure out proper solution to water break sensor (a: try better pump? b: replace sensor?)

Laser does work, though not yet from triggering on the front panel (or via Gcode)

Software: I suggest K40 Whisperer, as the LaserDRW thing it came with is not so hot.

Usage: It's not ready yet, so DON'T USE IT. That said, turn on the outside exhaust fan if you do eventually use it.

Safety considerations: https://techbravo.net/hosting/knowledgebase/4191/CO2-Laser-Engraver-Safety.html

  • NO ABS - Cyanide gas is bad for you
  • NO PVC OR VINYL-BASED MATERIALS - Chlorine gas is bad for you

Upgrades to consider in the near term:

Upgrades to consider eventually?:

  • improved controller board (Smoothie? DSP?)

Documentation dump:

k40_laser_engraver.1540411095.txt.gz · Last modified: 2018/10/24 15:58 by sdh7

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki