k40_laser_engraver
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| k40_laser_engraver [2018/11/11 04:37] – sdh7 | k40_laser_engraver [2018/11/11 04:38] – sdh7 | ||
|---|---|---|---|
| Line 42: | Line 42: | ||
| Power levels: | Power levels: | ||
| - | * Wood (engraving) - 8% | + | * Wood (engraving) - 8% does a fine job on the random plywood pieces we've tested with. |
| * Acrylic - 25% was great for engraving, but slightly insufficient for cutting (the cut edges did snap off easily, though) | * Acrylic - 25% was great for engraving, but slightly insufficient for cutting (the cut edges did snap off easily, though) | ||
k40_laser_engraver.txt · Last modified: 2021/07/13 23:24 by sdh7