introduction_to_the_internet_of_things
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| introduction_to_the_internet_of_things [2018/07/12 00:04] – sdh7 | introduction_to_the_internet_of_things [2018/07/30 15:40] – sdh7 | ||
|---|---|---|---|
| Line 39: | Line 39: | ||
| ==Hardware Construction== | ==Hardware Construction== | ||
| * On the programming board, wire an SPST or SPDT switch between GPIO and GND | * On the programming board, wire an SPST or SPDT switch between GPIO and GND | ||
| - | * If you plan on re-using the boards for something else in the future, solder in header pins on the other boards. If you're building this as a | + | * If you plan on re-using the boards for something else in the future, solder in header pins on the other boards. If you're building this as a fixed-in-place design, you'll want to just solder wires to the boards. Theoretically, |
| + | * wiring: TBA | ||
| | | ||
| - | If you want to re-use the component boards for other projects, solder pins into the BME280/ | + | |
introduction_to_the_internet_of_things.txt · Last modified: 2018/08/22 15:09 by sdh7