introduction_to_the_internet_of_things
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| introduction_to_the_internet_of_things [2018/07/10 23:34] – sdh7 | introduction_to_the_internet_of_things [2018/07/11 23:11] – sdh7 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====THINGS TO DO BEFORE THE CLASS==== | ||
| **Software Setup** | **Software Setup** | ||
| You should do the following things before the class: | You should do the following things before the class: | ||
| Line 27: | Line 28: | ||
| and then add #define CLASS_BME280 at the beginning of your program, so that way if you get an Adafruit BME280 board in the future, it will continue to work right... | and then add #define CLASS_BME280 at the beginning of your program, so that way if you get an Adafruit BME280 board in the future, it will continue to work right... | ||
| + | ====THINGS WE WILL DO AT THE CLASS==== | ||
| ==Hardware Construction== | ==Hardware Construction== | ||
introduction_to_the_internet_of_things.txt · Last modified: 2018/08/22 15:09 by sdh7