User Tools

Site Tools


introduction_to_the_internet_of_things

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
introduction_to_the_internet_of_things [2018/08/01 00:44] sdh7introduction_to_the_internet_of_things [2018/08/22 11:09] (current) sdh7
Line 40: Line 40:
  
 ==Hardware Construction== ==Hardware Construction==
 +  * First things first- TEST THE VOLTAGE REGULATOR BOARD. Unfortunately, these boards are capable of failing short (i.e. the input voltage can end up at the output, which will fry your ESP8266!!). Hook up your power source to the Vin of the regulator board. Using a voltmeter, check the voltage at Vout. It should be about 3.3V, give or take .1 V. If it is more than this, get another board and throw this one away!
   * On the programming board, wire an SPST or SPDT switch between GPIO and GND   * On the programming board, wire an SPST or SPDT switch between GPIO and GND
   * If you plan on re-using the boards for something else in the future, solder in header pins on the other boards. If you're building this as a fixed-in-place design, you'll want to just solder wires to the boards. Theoretically, the person that designed this de-solders the pins from the ESP8266 board, but that seems foolhardy to me (makes it MUCH more difficult to reprogram...)   * If you plan on re-using the boards for something else in the future, solder in header pins on the other boards. If you're building this as a fixed-in-place design, you'll want to just solder wires to the boards. Theoretically, the person that designed this de-solders the pins from the ESP8266 board, but that seems foolhardy to me (makes it MUCH more difficult to reprogram...)
introduction_to_the_internet_of_things.txt · Last modified: 2018/08/22 11:09 by sdh7

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki