hp_1660cs_logic_analyzer_and_oscilloscope
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
hp_1660cs_logic_analyzer_and_oscilloscope [2019/03/26 21:01] – faehnrich | hp_1660cs_logic_analyzer_and_oscilloscope [2019/03/26 21:20] – faehnrich | ||
---|---|---|---|
Line 35: | Line 35: | ||
Connect to what you're trying to analyze, both signal and ground. | Connect to what you're trying to analyze, both signal and ground. | ||
+ | Select Waveform, either from the menu next to the main menu button, or just press the "W form" button on the front panel. | ||
+ | Change how much is displayed with sec/Div, the dial should control that. Dial in how much "Next Sample Period" | ||
+ | |||
+ | Hit Run in the upper-right of the screen, or the button in the upper-right of the front panel. | ||
+ | |||
+ | With sec/Div still selected, you can dial in the displayed sample period to see the signal. | ||
+ | |||
+ | Select Delay, and the dial can move the signal left and right. | ||
+ | |||
+ | {{ : | ||
hp_1660cs_logic_analyzer_and_oscilloscope.txt · Last modified: 2023/10/10 22:05 by davidk