User Tools

Site Tools


This is an old revision of the document!

HOWTO use Inkscape for our Laser Cutter

This is not a detailed document on how to use Inkscape in general- there are other resources online for that. It's just enough to format things for K40 Whisperer.

  • 1st Step: Set your document size (shift-ctrl-D)
  • If you're just raster engraving, draw or import or whatever into the document. It should be in black/greyscale. Non-black/blue/red colors may interpret as greyscale of some sort?
howto_inkscape_for_the_laser.1542743226.txt.gz · Last modified: 2018/11/20 14:47 by sdh7