howto_inkscape_for_the_laser
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
howto_inkscape_for_the_laser [2018/11/20 15:38] – sdh7 | howto_inkscape_for_the_laser [2018/11/20 15:39] – sdh7 | ||
---|---|---|---|
Line 11: | Line 11: | ||
Inkscape/ | Inkscape/ | ||
- | | + | |
+ | This is somewhat tricky to install correctly. It requires a built-from-source version of Inkscape (I used Homebrew, though the version on there has a broken dependency. I then had to hand-apply a patch that hadn't been accepted yet.), and a number of Python libraries. You also have to run it via sudo, as PyUSB can't open the serial port as non-root. |
howto_inkscape_for_the_laser.txt · Last modified: 2018/11/27 11:38 by sdh7