howto_3d_print
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| howto_3d_print [2018/12/03 14:24] – created sdh7 | howto_3d_print [2018/12/03 14:26] (current) – sdh7 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====HOWTO 3D Print==== | ====HOWTO 3D Print==== | ||
| - | Tools needed: | + | This is mostly for use with Cura on the i3. Other slicers/ |
| + | |||
| + | |||
| + | ==Tools needed:== | ||
| * Design file | * Design file | ||
| * Slicer Software | * Slicer Software | ||
| Line 7: | Line 10: | ||
| * Print removal tool | * Print removal tool | ||
| + | |||
| + | ==Basic Procedure== | ||
| * You'll need a design file. STL format is preferred. OBJ and a few other types are supported, but STL is the primary one. If you don't have a design file, you'll need to make one using whatever tool you want. That is beyond the scope of this document. | * You'll need a design file. STL format is preferred. OBJ and a few other types are supported, but STL is the primary one. If you don't have a design file, you'll need to make one using whatever tool you want. That is beyond the scope of this document. | ||
| * Open the Slicer software. We prefer Cura, and it should be installed on many of the computers floating around the space. If it's not, install it! If you're using some other software, the steps may vary a bit from here out. | * Open the Slicer software. We prefer Cura, and it should be installed on many of the computers floating around the space. If it's not, install it! If you're using some other software, the steps may vary a bit from here out. | ||
howto_3d_print.txt · Last modified: 2018/12/03 14:26 by sdh7