Differences

This shows you the differences between two versions of the page.

--- hot_wire_cutter [2018/07/27 11:54] – sdh7
+++ hot_wire_cutter [2018/11/14 10:29] (current) – sdh7
@@ Line 9: / Line 9: @@
 ^Serial| N/A|
 ^Arrival Date| 2014|
-^Working| no |
+^Working| yes |
 ^Contact| Steve Gray|
-Current Status: Transformer released the magic smoke. Need to replace with PWM controller
+Current Status: Original 1-2 A rectifier system replaced with 6A power supply and PWM regulator. Way more power than necessary. Wire gets red hot in a few seconds at 30-50% on the controller.
 A DIY'd hot wire cutter on loan from Steve. Uses a Craftsman router table as its table.
-The power light is non-functional, so unplug after using.
+You'll know if it's still on, as it makes quite a hum when it's getting power. Unplug when not in use.
-{{tag>[needs_details needs_minor_repair]}}
+{{tag>[]}}