enco_drill_press
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
enco_drill_press [2017/01/09 22:22] – sdh7 | enco_drill_press [2017/01/09 23:01] – sdh7 | ||
---|---|---|---|
Line 23: | Line 23: | ||
Work Needed: | Work Needed: | ||
- | *< | ||
- | *< | ||
- | *< | ||
*Needs additional feed lever arms (has one, currently) | *Needs additional feed lever arms (has one, currently) | ||
*These are curious. The existing one is something ever so slightly smaller than 1/2" (12mm?), but testing a 1/2" bolt in some of the holes seemed to be a good fit, so we should be able to fabricate or find acceptable replacements. | *These are curious. The existing one is something ever so slightly smaller than 1/2" (12mm?), but testing a 1/2" bolt in some of the holes seemed to be a good fit, so we should be able to fabricate or find acceptable replacements. | ||
*Suggestion: | *Suggestion: | ||
*simpler solution - get a few feet of 1/2" threaded rod and get 1/2" threaded knobs ($3 each from McMaster or Grainger) | *simpler solution - get a few feet of 1/2" threaded rod and get 1/2" threaded knobs ($3 each from McMaster or Grainger) | ||
- | *< | ||
- | *Table connector diameter - 1.850", | ||
- | *Somehow epoxy .010" shim stock onto the table connector? | ||
- | *Thicken material by welding? | ||
- | *Solution currently in place- a cut up soda can was a thick enough shim to tighten down fully. | ||
*< | *< | ||
enco_drill_press.txt · Last modified: 2018/01/14 22:18 by sdh7