enco_drill_press
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
enco_drill_press [2017/01/10 02:59] – sdh7 | enco_drill_press [2017/01/10 03:22] – sdh7 | ||
---|---|---|---|
Line 30: | Line 30: | ||
*Suggestion: | *Suggestion: | ||
*simpler solution - get a few feet of 1/2" threaded rod and get 1/2" threaded knobs ($3 each from McMaster or Grainger) | *simpler solution - get a few feet of 1/2" threaded rod and get 1/2" threaded knobs ($3 each from McMaster or Grainger) | ||
- | *< | + | |
- | *This should be a high priority - remnant has a crack and probably isn't long for this world | + | |
- | *Make something in Aluminum on the [[MaxNC]]? | + | |
- | | + | |
*Table connector diameter - 1.850", | *Table connector diameter - 1.850", | ||
*Somehow epoxy .010" shim stock onto the table connector? | *Somehow epoxy .010" shim stock onto the table connector? | ||
*Thicken material by welding? | *Thicken material by welding? | ||
*Solution currently in place- a cut up soda can was a thick enough shim to tighten down fully. | *Solution currently in place- a cut up soda can was a thick enough shim to tighten down fully. | ||
- | *< | + | *< |
Future work that could be done: | Future work that could be done: | ||
*Set up depth stop/gauge mechanism? | *Set up depth stop/gauge mechanism? | ||
+ | |||
+ | {{tag> |
enco_drill_press.txt · Last modified: 2018/01/15 03:18 by sdh7