User Tools

Site Tools


davinci_xyz_1.0

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
davinci_xyz_1.0 [2022/02/09 21:11] sdh7davinci_xyz_1.0 [2022/04/12 23:10] (current) sdh7
Line 9: Line 9:
 ^Serial| -| ^Serial| -|
 ^Arrival Date| 6/1/2021| ^Arrival Date| 6/1/2021|
-^Working| No|+^Working| Yes|
 ^Contact| Makers' Alliance| ^Contact| Makers' Alliance|
  
 Current Status: Needs Calibration Current Status: Needs Calibration
  
-Updated the stock firmware to [[https://github.com/luc-github/Repetier-Firmware-4-Davinci|Repetier 0.92]], so it no longer needs chipped filament. We've tested moving the axes around and heated up the bed/extruder and those seem fine.+Updated the stock firmware to [[https://github.com/luc-github/Repetier-Firmware-4-Davinci|Repetier 0.92]], so it no longer needs chipped filament (Yay!)
  
-Talks to Repetier-Host on my laptop, but not Cura?+Now part of the [[Octoprint]] farm http://octoprint.local:8084
  
-Next steps are to manually level the bed, attempt a print, and then hook it into our [[Octoprint]] setup.+For your Cura Profiles: 
 +Start Gcode: 
 +<code> 
 +G28 
 +</code> 
 + 
 +End Gcode: 
 +<code> 
 +M104 S0 
 +M140 S0 
 +G91 
 +G1 F150 
 +G1 Z10 
 +G90 
 +G28 X0 
 +G28 Y0 
 +M8 
 +</code> 
 + 
 +Build Envelope is 200x200x200. Gcode Flavor is Repetier. 
 + 
 +Also note that the build platform is a little backwards compared to the other printers- the origin is the back left of the print bed, so prints will be "mirrored" relative to where you put them in Cura.
  
 {{tag>[needs_maintenance needs_calibration   ]}} {{tag>[needs_maintenance needs_calibration   ]}}
davinci_xyz_1.0.1644459066.txt.gz · Last modified: 2022/02/09 21:11 by sdh7

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki