User Tools

Site Tools


bigcnc

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
bigcnc [2019/01/15 12:25]
sdh7
bigcnc [2019/01/17 12:26]
sdh7
Line 29: Line 29:
     * Turn down end of leadscrew     * Turn down end of leadscrew
   * Y axis   * Y axis
 +    * Cut down rails to length if necessary?
     * attach rails to base     * attach rails to base
     * tap delrin nuts      * tap delrin nuts 
-    * cut leadscrews+    * cut leadscrews ​to length?
     * turn down leadscrews     * turn down leadscrews
   * Z axis   * Z axis
-    * attach spindle mounts+    * <del>attach spindle mounts</​del> ​
     * attach to X axis     * attach to X axis
   * Table   * Table
Line 44: Line 45:
     * Wire up everything     * Wire up everything
     * Procure motors if needed?     * Procure motors if needed?
 +  * Misc
 +    * Dust collection setup?
 +    * Vacuum hold-downs? (optional)
 +    * <​del>​Clean up cast parts</​del>​
  
  
bigcnc.txt ยท Last modified: 2019/01/17 12:26 by sdh7